pseudo copper
I got a iflight turbobee 136rs v2 for free from a buddy and when I went to check it out on betaflight config, I was met with the message thats in the screenshot.
I was thinking of just using an older version that would support a API version 1.40 but can't figure out how to do it. Any help would be amazing!
trail spire
I got a iflight turbobee 136rs v2 for free from a buddy and when I went to check...
You can most likely just flash the newest version
civic finch
Just go to Github and get Betaflight Configurator 10.7.2
I'm pretty sure it'll work with Betaflight 3.5. Get an earlier version if it doesn't.
https://github.com/betaflight/betaflight-configurator/releases/tag/10.7.2
whole haven
pseudo copper
You can most likely just flash the newest version
I tried to do exactly that but it just got stuck. It would never pass the rebooting stage before it could even start the firmware update.
pseudo copper
Just go to Github and get Betaflight Configurator 10.7.2
I'm pretty sure it'll w...
I believe I am using that, it prompts be with the message about the API and doesn’t allow me to update the firmware. It gets stuck at the reboot before it can update the firmware.
whole haven
here is some reasons/fixes for not connecting and/or DFU mode: https://hackmd.io/@nerdCopter/rJv5TUrQ2
But ideally you should be able to either:
a) just configure what you have with Configurator 10.7 or 10.8 , or
b) press/hold boot-button while plugging USB, then release. should get you DFU mode for flashing. it will erase everything.