Flight in Sunset analog problems

[lucid agate]

Hi I have the following problem I actually love to fly a few batteries in the sunset but I have that when I change from sun to direction no sun my analogue image only becomes really bright and then very dark can you deactivate the automatic light ratio adjustment somewhere in the osd menu?

[merry lotus]

it depends on the camera you use, some cameras has camera control function

[lucid agate]

I use the caddx ant, I also have the osd menu board for it, but unfortunately I have no idea what I have to set there

[lucid agate]

Unfortunately, I don't know what the light darkening is affected by because I have no idea about contrast sharpness and the other factors

[merry lotus]

I'd start from wdr function

[lucid agate]

That's the point of what the wdr function means, so what does it do? I'm also pretty new to it, so I've been in the helicopter 3D area for a long time, so when it comes to the settings on the copter that it affects the flight, as far as the camera is concerned, it's all new territory for me.

[lucid agate]

I apologize for my English if it is bad because I am writing with the translator because my English is really bad

[merry lotus]

it is wide dynamic range - it gives camera ability to show pictures with high contrast (very bright and dark areas in one frame)

[merry lotus]

no problem i'm not native english speaker too

[lucid agate]

Ok, I come from Germany so I rarely use English and well I lose a lot of knowledge over time.

[lucid agate]

Great, thank you, I'll take a look and write again as soon as I find something or hopefully it's improved

[lucid agate]

hi, now I have a much more annoying problem and I flew around once and it worked fine even after changing the setting. However, with the 2 battery, after about 15 to 20 minutes of using the eachine ev 100, the picture gradually appeared The range got worse until the connection was completely lost to just a few cm. It's not the copter's fault. I also tried another one and it didn't work either. After about half an hour and I was back at home in between, it worked again. Does anyone have any idea what the problem is?

I'll say that I had this googles before and they've never caused such a problem

[lucid agate]

?

@merry lotus?

[merry lotus]

Could be anything. Overheating?