#RX_FAILSAFE, MSP, RPMFILTER
1 messages · Page 1 of 1 (latest)
Cannot arm with USB plug in, RPMFILTER means no signal from ESCs(have you plugged battery in?)
What RX are you using?
Both that and RPMFILTER will stop you from flying. MSP is USB, you can ignore that
msb i know
this error pops up
after souldering
gps
but right now
i get that off my quad
so my RX pads are clear
It was working fine and flying before?
yea
Ok a good place to start then would check for solder balls, bridges, shorts, bits of wire
Post a photo of your FC showing the wiring
How did you attach GPS?
You have likely done damage as a result of that, post a photo or I cannot help you any further
okay okay
This 2 on the left side
I didn’t use this ones
I used 5V on the right side of gnd on the right side and TX6 and RX6 because they were free.
Post a better photo of the area above the arrow on the left hand side by the grommet please
yeaaa
i think it can be it
BUT
other switches works
only arming
doesnt work
buzzer and other things works perfectly fine
with my app
You need a new flight controller
From your transmitter or just from your phone?
Motors?
i cannot arm
Gyro?
You can test motors through motors tab in BF configurator and gyro too
Doesn't really change anything though, it was working, now it's not working and you have physical damage. You need a new FC at minimum
Go test gyro and motors and report back
okok
And get a diff all from BF CLI while you're at it
What does the warning tell you?
all 4
works perfectly fine
now
there is only rx_failsafe error
bcs msp
does not count
So you do not have RPMFILTER error any more?
no
Post a diff all
What transmitter do you use?
im using dji system
Ok well, everything is fine here. Your ESC is fine
new fc?
Yup
You're capable of figuring that out, go do some research and make sure you find one with the same plug and pinout
okay thanks bro
And next time when soldering GPS take more care and maybe think about testing it with 5v power from somewhere else like a USB plug so you don't blow your new FC up in case it is faulty GPS
I cannot say whether there was any problems with your wiring because you already undid it
yeaaaa
thanks
i used smoke stopper in case something would not go right
but it didnt stop it
thanks bro
❤️
right now everything everything is fine
i fixed
it
fc is alive
thank god

What did you do?
Factory reset
Un-plug everything
Plug in
And i also delete all gps settings
Then
Error was still there
I plugged battery
Rx_Failsafe disappear
And only msp
Stays
I unplug everyting
Plug Googles battery And transmitter
And it worked
Sorry for my english
😕
Oh And i also pair my transmitter again
With vista
I can not really tell which of this things help me to fix it
🤷🏽♂️
XDdD