#NeutronRC F411 Blackbox not detected on 4.4.2

1 messages · Page 1 of 1 (latest)

pearl rock
#

support ID: 3ef431d4-b4b4-4421-b729-3dbc28e62817 (normal, not core only)

with Core only on 4.4.2 ↓
`version

Betaflight / STM32F411 (S411) 4.4.2 Jun 6 2023 / 21:55:00 (23d066d08) MSP API: 1.45

config: YES

board: manufacturer_id: NERC, board_name: NEUTRONRCF411AIO

status

MCU F411 Clock=108MHz (PLLP-HSI), Vref=3.31V, Core temp=31degC
Stack size: 2048, Stack address: 0x2001fff0
Configuration: CONFIGURED, size: 3752, max available: 16384
Devices detected: SPI:1, I2C:1
Gyros detected: gyro 1 locked dma
GYRO=BMI270, ACC=BMI270, BARO=DPS310
OSD: MAX7456 (30 x 13)
BUILD KEY: 957aed4f23d1ffb2cac57da62711932e (4.4.2)
System Uptime: 16 seconds, Current Time: 2023-09-02T19:57:17.074+00:00
CPU:24%, cycle time: 304, GYRO rate: 3289, RX rate: 15, System rate: 9
Voltage: 2 * 0.01V (0S battery - NOT PRESENT)
I2C Errors: 0
SD card: Not configured
FLASH: JEDEC ID=0x00ef4018 16M
Arming disable flags: RXLOSS CLI MSP RPMFILTER

flash_info

Flash sectors=256, sectorSize=65536, pagesPerSector=256, pageSize=256, totalSize=16777216 JEDEC ID=0x00ef4018
Partitions:
0: FLASHFS 0 255
FlashFS size=16777216, usedSize=36864

dump hardware

version

Betaflight / STM32F411 (S411) 4.4.2 Jun 6 2023 / 21:55:00 (23d066d08) MSP API: 1.45

config: YES

start the command batch

batch start

board_name NEUTRONRCF411AIO
manufacturer_id NERC

...
`

image.png
drowsy viper
#

This target has been recently updated to include flash (sept 7th). It looks like your build is from Sept 2nd. Please try flashing normally again and confirm that flash works.

pearl rock
#

It isn't there on the oct 12 build either..

image.png
pearl rock
#

Do I have to add some custom define?

drowsy viper