#Cant get Betaflight OSD to work on DJI goggles (v1)

1 messages · Page 1 of 1 (latest)

cobalt mulch
#

I can't seem to get Betalight OSD to work on my goggles, i have followed a few guides on how to get it to work but no matter what i do i cant seem to make it work. i have installed WTFOS on both the runcam link and the dji goggles and installed the MSP-OSD packages. i have made sure that the correct UART is enabled with VTX (MSP + Displayport). I have also tried installing the OSD for fpv.wtf preset in betaflight. Also another bit of information which i'm not sure is important or not but I'm not able to see the drone's voltage in the goggles, i have searched it and everything ive seen just says to make sure that the correct UART is enabled and I'm sure that I have the right UART enabled (As im using the port on the FC which uses T1 , R1 and have UART 1 enabled but i am still kinda new to this so i might just be making a rookie mistake) . i will attach the dump file of my FC incase that can provide any useful information

I'm using:
Betaflight 10.9.0
SpeedyBee F405 V3 BLS 50A 30x30 FC&ESC Stack (4.4.2 Firmware)
Runcam link falcon Nano (V01.00.0608)
DJI FPV Goggles V1 (V01.00.0608)

📎 BTFL_cli_20230819_120659.txt
grave bluff
#

Did you disconnect sbus wire from FC? Many FC’s don’t work if connected

cobalt mulch
#

Yeah I’ve got the sbus and the ground wire next to it disconnected because when it was connected it was messing with my receiver

marsh crest
#

Hey, you have to activate Telemetry in Betaflight.

#

I think it is on the receivers tab

#

As far as i know, but im not shure. On BF 4.4 it is on Receivers tab i think.

#

I always forget it to activate, thats why im telling you and hope you forgot 2 😂

cobalt mulch
marsh crest
#

Ok and on OSD Tab enabled as well?

#

Have you made the commands for MSP Displayport and OSD in CLI?

cobalt mulch
#

Yeah I’ve done both of them things