#Ruined new iH3

1 messages · Page 1 of 1 (latest)

proven pawn
#

Hi FPV gurus!

I have updated iFlight iH3 to BetaFlight 4.4.1 following their instructions from: https://iflightrc.freshdesk.com/support/solutions/articles/48001148115-firmware-wiring-factory-dumps?fbclid=IwAR22D1BolBjgauKJxYiFvupW8TvtoV2_UNHLaUzN0qoPmtnESRFHi5I4j5M

  1. Created BetaFlight backup file
  2. Selected and flashed IFLIGHT_BLITZ_F722 target with 4.4.1 firmware version
  3. Applied default custom settings when BetaFlight asked after reboot
  4. Applied iH3 factory dump 4.1.2.txt from their google drive
  5. Applied BetaFlight backup file
  6. Rebooted

Now I'm stuck with:

  1. No barometer detected
  2. No GPS
  3. PID profiles are not set and Rates are default to BetaFlight
  4. Receiver doesn't receive any commands although radio is green
  5. Modes are reset6. Motors show 100% errors and don't spin when I move Master slider
  6. Nothing is Servos. Just shows "Servos requires firmware >= 1.10.0 and target support"

I'm literally pulling my hair blaming myself for this
Please please please help!

iFlight Support
iflight wiring diagrams factory dump

Please use our GoogleDrive Database to download the latest version of our hardware wiring diagrams on which you can also find the correct Betaflight target or to download and restore your factory settings of your iFlight BNF! Link: https://dr...

proven pawn
#

I managed to flash BetaFlight 4.3.1 and restore it from the backup. Is there any way to upgrade to Betaflight 4.4.1?

echo canyon
plain linden
#

Skip 4.4.1 and use 4.4.2 pre-release

image.png
proven pawn
plain linden
#

As it fixes most issues encountered in 4.4.1