my serial ports are switching off after save and reboot
#serial ports switching off
pearl onyx
shut pawn
my serial ports are switching off after save and reboot
What is the configuration that you're trying to save? Show a screenshot
pearl onyx
vtx and reciver
shut pawn
A screenshot would be helpful
Set the settings you want to save, and send a screenshot of that
empty pumice
Usually means that you have tried to input an "impossible" configuration. Are you using the latest configurator?
pearl onyx
yes
4.4 rc5
n i rectified it the company a dedicated slots for everything
@empty pumice @shut pawn but one thing i want knw for reciver
in our FC boards we connect tx to rx n rx tx
shut pawn
Yes
empty pumice
in our FC boards we connect tx to rx n rx tx
yes, RX is always receive and TX is always transmit on each side respectively. TX to RX, RX to TX.
shut pawn
@pearl onyx could you get a screenshot of what you were trying to save?
pearl onyx
all cleared now thanks
pearl onyx
@shut pawn @empty pumice <@&898776427095269377>
cerulean wave
<@367656454087245825> <@492724642063319061> <@&898776427095269377>
you can't use Smart audio on the same port as MSP
and plz dont tag all admins lol
still falcon
Why have you got msp on uart 5?
You should have the VTX and the rx on differnt uarts. What’s the hardware your using
pearl onyx
all cleared but one thing is
device ready showing no
@shut pawn
@still falcon @cerulean wave
shut pawn
and plz dont tag all admins lol
And then they did anyway...
@pearl onyx you'll have to be patient
I do not have the time nor mood for this now