betafpvf4sx1280 12a f4 aio gyro not showing in motor tab

[low kite]

so that is what i found out now
4.3.2 - 4.4RC5 - bluejay 24khz & 48khz no gyro signal in motor tab and laggy accelerometer
4.3.1 - bluejay 48khz no gyro signal
4.3.1 - bluejay 24khz gyro signal

and if im changing motor protocol it takes like 6 seconds for the gyro to move again

[low kite]

just downloaded bluejay to flash local this made 48khz work on 4.3.1 so i tried it on 4.4rc5but gyro wont move

[scenic badger]

Do you actually have the BetaFPV board or is it a DarwinFPV clone? If it's the darwinFPV one please use the DARWINF4SX1280HD target

We used to make all boards work with all hardware - but now space is becoming limited so the BetaFPV target only includes the gyro models that BetaFPV ship on their boards, if you have another board that is a clone you will need to use the target from your manufacturer.

If it is a BetaFPV board then we can update it, but we've talked to BetaFPV and their targets should all be up to date now.

[low kite]

i try havent seen you replied

[low kite]

i just flashed it and still i have abnormal amount of shaking

i mean it came in a betafpv box

no clue if it is a clone

[scenic badger]

Oh, sorry. If it's a betafpv board then use the betafpv targets.
If you get shaking it will be a mechanical or tuning issue. Describe the build?

[low kite]

it is doing that without anything attatched to it

it is the same with darwin hex always stays in calibration mode

i bought from this shop https://de.aliexpress.com/item/1005003570493798.html?spm=a2g0o.order_list.order_list_main.44.5fe25c5fiQ1ejs&gatewayAdapt=glo2deu

already got my money back but i hoped i could make it fly with my 3d printed walksnail 1vtx build

seems like with darwin calibration flag goes sometime aways after some time

nvm shaking again...

anything else i can try?