#ZYNtastic for Heltec v3

1 messages · Page 1 of 1 (latest)

short imp
#

I present to you all, my latest creation... ZYNtastic. Available on Printables here: https://www.printables.com/model/1043785-zyntastic-case-for-the-haltec-v3

Inspired by my friend Z3R0, this case for the Haltec v3 meshtastic board fits inside of a ZYN can. With just enough room for the included antenna and a 750mAh batter (no idea where it is from, it was laying around). The whole assembly can come out for charging or you could cut a hole for the usb-c charger and glue this in place.

I recommend doing 2 wall thickness and about 20-50% infill to make the bottom a tab heavier. The lid may have trouble staying on if the tolerances are not perfect. This design is a mess of polygons and far from my best work, sorry about that lol.

IMG_1165.jpeg IMG_1164.jpeg IMG_1163.jpeg IMG_1166.jpeg IMG_1161.jpeg IMG_1156.jpeg
Printables.com
ZYNtastic case for the Haltec v3 by nopack | Download free STL mode...

This case for the Haltec v3 meshtastic board, antenna, and 750mAh battery is designed to fit in a standard ZYN can. | Download free 3D printable STL models

civic carbon
shell zinc
#

Of course someone would make a Zyn enclosure lol!

#

Great form factor though for the pocket!

short imp
shell zinc
#

If there's dead space you should make a version where there is still a small slot for more zyns to be stowed lol

uneven horizon
#

Lots of people make pouches from fabric and kydex etc for tobacco tin & zyn cans