#[ACOS] TS1 Lilygo T-Beam SUPREME Case
void tusk
void tusk
I added a new two piece vertical molle clip so if you are using PLA+ it will be a lot stronger since the layer lines will be the right orientation. If you're using PETG, the old one is fine, at least it is for me, but this new one is really nice.
chrome dirge
Accidentally printed with 0% infill but i think it will work... Will make sure the the other side has infil before printing...
void tusk
Accidentally printed with 0% infill but i think it will work... Will make sure t...
Just don't tighten the screws too much!
void tusk
Alley Chat TS1 Lilygo T-Beam SUPREME Case by Alley Cat
chrome dirge
Just don't tighten the screws too much!
It has held up well so far. Even with no infill the horizontal layers provide enough strength. Tight enough. Also have the new vertical Molle clip.
void tusk
Finally got the Baofeng clip done for the 'beams.
chrome dirge
Loading some angry pixies while riding the Raide-Jokeri.
https://raidejokeri.info/en/jokeri-light-rail-from-itakeskus-to-keilaniemi/
void tusk
Loading some angry pixies while riding the Raide-Jokeri.
https://raidejokeri.in...
That's awesome!
chrome dirge
By Rhodes Acropolis (under restoration) and obligatory local cat. No contact with any other nodes. From the right spot it should be possible to reach Türkiye.
past sinew
Finally got the Baofeng clip done for the 'beams.
Very nice !!!!