I’m having a problem trying to make a 3 way splitter, the circuit just stops working when I walk away, or if I run it for too long. Is there any fixes or is logic just messed up. I’ll post images of circuitry when I can
#problem with logic
vagrant swallow
vagrant swallow
basically the button activates the bottom delay, and the first t flip flop
for 10.0 power
then the first delay flips the first flip flop off, and the second one on, also sending a signal to the second delay. the second delay turns the second flip flop off and the third flip flop on, the third delay turns the third flip flop off and the fourth flip flop on, and the fourth delay turns off the fourth flip flop off and the first one on.
the fourth delay instead of going into the first delay goes into an and gate, which allows me to stop the loop whenever i want by turning off the switch
the buttons on the flip flops are used to turn on and off t flip flops if any of them malfunction
the flip flops power their respective relays to allow the proper power into the interactor which interacts with the 4 way conveyor to make it go right, forward, left, forward etc.
for whatever reason it breaks whenever its on too long
old prairie
You should use an incrementor and and gates so it doesn't break
vagrant swallow
You should use an incrementor and and gates so it doesn't break
Where should I put these?
vagrant swallow
It's the whole circuit
i need it to output 0,10,2,10, loop
oh
actually i think it would work with relay instead of and
cause and needs to have equal values on both inputs
ignore this^ i dum
thanks :)
vagrant swallow
whats the greater then sign thing?
old prairie
whats the greater then sign thing?
greater than gate
vagrant swallow
greater than gate
i cant find it :(
old prairie
I think it's under something else on the top shelf across the checkout