have you set up the throttle, yaw, pitch, and roll assignments on your controller?
#Drone Motors not functioning
woven flame
in the profile that you binded your drone to, you need to set "rules" for stick movements to be certain commands
those which are sent through the receiver protocol and then in essence make it fly
cinder isle
have you set up the throttle, yaw, pitch, and roll assignments on your controlle...
I am pretty sure the TBS tango 2 comes with these pre assigned but maybe not
I will check.
woven flame
the next step is to verify that the receiver is picking up the commands
after you check if the sticks are set up on the controller side, turn on your controller, plug in your drone into betaflight and go to the "receiver"tab
then move the sticks, if they move, verify the simulated drone next to the sticks matches what you put in
roll = roll, yaw should do a yaw motion, etc
cinder isle
In Betaflight, the movements for pitch roll yaw and throttle are different than what it is set to on the controller.
woven flame
you can switch around the 4 letters
TAER or something like that, whatever it is for you, you can move those letters around from left to right
to get it to match up
cinder isle
I got it to work. TYSM for the help !!