#[0.10.7.7] Ice blocks sink in water when in different room.

1 messages · Page 1 of 1 (latest)

round summit
#

Steps to reproduce:

  1. Push an ice block over water such that when it comes to a stop, it is fully over the water.
  2. Leave the room.
  3. Wait 6 seconds -- this is the time it normally takes for the ice path it creates in water to melt.
  4. Return to the room.
  5. The ice block will vanish with VFX suggesting it sank in the water. A single tile of ice will be left behind.
fringe pawn
#

Ooooooo hahhahah

#

LOL

fringe pawn
#

does it have to be a non 1x1 block?

shut wyvern
#

I've also noticed some editor jankiness with ice blocks that start on top of water tiles sometimes sinking once you enter play mode - don't know if it's the same root cause

fringe pawn
#

thats weird yea

#

ive never seen that happen

#

can you clip that?

shut wyvern
#

I'll try; I haven't been able to figure out exactly what causes it so it's hard to recreate

fringe pawn
#

yea i imagine haha

#

i had that in the past but then fixed it

#

weird

shut wyvern
#

I've had it happen only once on current patch, and after exiting and re-entering play mode I can't seem to make it happen again