Ignore the messy cables I'm just trying to get it powered first and make sure I get boot and all parts run fine before I seal it up and do all the work of cable management
#No power
random plume
Ignore the dust aswell. Just some old fans that need wipe down. Need this to work first
random plume
This is the big MB cable to clarify right?
This is exactly as it was before
It worked on the previous board without a hitch
waxen void
yeah that's your 24 pin...you also want to make sure the 8 pin EPS is also plugged in as well....and i can't tell but is the SW and reset on the right set of pins?
random plume
Those are the pins I'm unsure of looking at the book I think they are but could be wrong
It's in all the way for sure
I think my fault here is in the SPH
waxen void
i just posted the pin layout for your front panel connectors...so might wanna double check it looks like you have them on the bottom row vs the top row but i can't tell from that angle
random plume
I had them on the left there near that audio cable, but I should have them closer to the right where they're sitting?
waxen void
I had them on the left there near that audio cable, but I should have them close...
you see the set of pins next to the sata cable?
random plume
Yep the SPH right?
POWER
I think I have them in the right order
Mb isn't throwing code
Hmmm it doesn't stay on
waxen void
give it a second it might be memory training and cut off and on a few times
did it post?
random plume
Not yet
I've powered on a few times each time it shuts off
It's posting
Hit bios
I'm aware of cooler not being plugged in
Looks right to me guess I'll run setup, if everything works ill shut it off, plug in cooler and cord it up
waxen void
aight so you might be okay...you want to also put your ram in the right slots...they should be in A2 and B2
