Digivice repair question

[green bobcat]

Hi! I found my childhood Digivice in my parents' attic 🥲 It's still working, but the back casing is broken. The screw and nut that hold it together are missing, and the plastic is cracked. I'd like to repair or replace it. I found a 3D print version online, but the only one I found is for the D-3. Is there another way besides getting another Digivice? The prices online are outrageous...

I'm not sure if this is the right place to ask this kind of question, but if not, I'll delete my message.

[regal void]

You could use duct tape

You could also figure out yh3 measurements for the nut and the bolt and buy replacements for them then just glue in the nut

[distant herald]

You could check Etsy for replacement parts too.

[scenic inlet]

Just go buy some small screws man 😭

[green bobcat]

While waiting to find the right type of screw and the nut that goes with it, I did this... it's disgusting but it works 🤨

[plush isle]

I found the back clip 3d print file maybe you can find a whole new case.

[green bobcat]

@plush isle Hooo 🙂 Do you have the link to the site where you can find it?

[plush isle]

The site is thingyverse

Here is the link to the back clip

https://www.thingiverse.com/thing:3378328

[plush isle]

Also can you tell me how big the bolt is for the back clip. That's the last part I need to fix my D2

[green bobcat]

@plush isle Unfortunately I don't have it anymore. And the bolt location of mi digivice is broken so I won't be able to measure it.
It seems to me that the screw was between 2.5 and 3 millimeters in diameter.