dusk island
One day I went to run my PenZ and noticed it made no sound when replacing the battery. I opened it up to find the speaker had somehow unalived itself! Someone here told me the part to use and I’ve now successfully replaced the speaker myself! I think I’ll keep it on sound more often than not now after the tedious work😂
full gazelle
it was hard to repair or change the buzzer?
dusk island
it was hard to repair or change the buzzer?
It was a little bit tricky removing the little speaker compartment ring because it's a pretty tight fit. After that I de-soldered the old buzzer from the black wire, and cleaned up the excess junk on the red wire. The replacement comes with wires already installed but they were so long and I didn't want to try trimming them or bending them to fit in the case. I de-soldered those off and then soldered the original wires to the new buzzer. I did all this without de-soldering the wires from the board becuase it is such a small soldering job in that spot, I didn't want to to mess up trying to be that precise.
full gazelle
nice to know, and where did u find the new buzzer?
dusk island
nice to know, and where did u find the new buzzer?
I used these:
Cheerock Pack of 20 Piezo Disc,... https://www.amazon.com/dp/B0BY6P3X89?ref=ppx_pop_mob_ap_share
full gazelle
Thanks a lot for the info!
dusk island
Of course! Did yours explode too?