Hi guys, now in trying to install klipper with mainsail in a mellow fly pi lite v2 and for me is impossible. i flash the system in the fly pi with a sd and this it does absolutely nothing
#I cant install klipper in a fly pi lite v2
tawdry citrus
sly hollow
What exactly are you doing?
The mellow fly pi lite v2 is a pi like SBC. So if it doesn't start with a mellow fly pi lite v2 image of linux, then you should contact the seller/manufacturer.
If you try to flash klipper onto it, that shouldn't work. I don't even know what settings you would try to do that.
If you flash MainsailOS and try to start that, you should have again a look at the supported devices: https://docs-os.mainsail.xyz/getting-started
As you can see, your current message doesn't specify at all, what you are trying to do
And just for your information Mainsail != MainsailOS
You cannot install klipper through mainsail. Mainsail is only running inside your browser
tawdry citrus
Hello! Sorry for answering now, I already managed to install what I need, now I am in the step of flashing the board (robin nano v1.2) when I take out the .bin file and insert it into the SD and insert it into the board, it does not work. it flashes and doesn't let me connect through the mainsail website
like this
sly hollow
So the file on the sdcard got renamed after flashing?
sly hollow
Ok then hit the firmware restart button and send the klipper log after that
Also send the output of ls /dev/serial/by-id
sly hollow
Change your serial to serial: /dev/serial/by-id/usb-1a86_USB_Serial-if00-port0
sly hollow
I said, send the output of that command and not your printer.cfg entry...
