I have set my accel at 5000mm/s but why does it always change to 500mm/s? | Mainsail | Page 1

slender stump Sep 15, 2023, 7:35 PM

#

peak tangle Sep 15, 2023, 7:59 PM

#

Probably your slicer is sending acceleration commands

radiant lynx Sep 15, 2023, 8:54 PM

#

Go to the printer config file and change it there, im p sure the settings in the main page are temporary and only last for each print

slender stump Sep 16, 2023, 8:08 AM

#

i did change it in teh printer.cfg file

slender stump Sep 16, 2023, 10:04 AM

#

i set the slicer accel command way higher than 6000

#

peak tangle Sep 16, 2023, 12:19 PM

#

Post your gcode

slender stump Sep 16, 2023, 12:32 PM

#

📎 Torch_holder.gcode

#I have set my accel at 5000mm/s but why does it always change to 500mm/s?