why cant I ssh into my pi?(using MacOs/Terminal)
#why cant I ssh into my pi?(using MacOs/Terminal)
fading wharf
stray vortex
Your Mac already has a cert for this IP and it is different.
ssh-keygen -R 192.168.1.135
After that, it should work again.
fading wharf
thanks
stray vortex
@fading wharf when all your questions are answered, pls close this ticket.
fading wharf
do you know a guide of how to install mainsnail os for the ender 3 s1(pro) because ive already installed mainsnail/klipper 3times but it still wont work.ive already contacted you a few days ago and mr.ying told me to kontact klipper discord.
i have sewerel guides but i was told these are not the right ones(aproved by you)
stray vortex
mainsailOS is just a preinstalled raspberry pi image with all software parts preinstalled. It's just flashing your sdcard and booting your pi. That's all you have to do, to install mainsailOS. It has nothing to do with your printer setup. That's your Klipper config and you have to flash Klipper on your printer board.
stray vortex
There is no official guide for any printer
stray vortex
And it depends which version of ender 3 you have and which board you have.
fading wharf
ah ok
stray vortex
The most important thing is to flash the board with the right MCU settings. After that, the settings itself are easy to change.
stray vortex
Only creality Boards are the worst one to flash. I don't know why creality hates people...
fading wharf
true even the support hates pupils
stray vortex
ok ill use these:
I don't know which board your printer has. Creality but different boards in different ender3 versions
fading wharf
i asked hem which thing i need to choose they told me to look at google and closed the conversation
its a 32it f401 chip board
stray vortex
Pls create a new ticket for flashing the board. Pls post a picture of your board + your current make menuconfig settings. These questions have nothing to do with this ticket.