Do you have a multi instance installation?
If so, please follow: https://crowsnest.mainsail.xyz/setup/installation/multi-instance-install
#hi i need help error created crowsnest
flat crypt
flat crypt
Why do you want to open crowsnest.conf?
midnight barn
no webcam detection
flat crypt
Also don't ping please
Your problem right now is that crowsnest didn't install
Opening the config won't do anything
I sent you the link that will help you to solve your problem
midnight barn
ty
midnight barn
@flat crypt do you have any idea why i dont have crowsnest log dont show it .. but now i can open crowsnest.conf
flat crypt
First of all don't use @ pings like @midnight barn @midnight barn @midnight barn @midnight barn @midnight barn
midnight barn
ho sorry
flat crypt
Second one, this message you posted, says, that it failed to install, so there is no log, if it didn't get installed
Did it succeed after you followed the link I sent earlier?
flat crypt
Send the output of systemctl status crowsnest
midnight barn
ok good now i have log but no webcam detect but raspi cam is detect in ssh
flat crypt
Then maybe send the log
midnight barn
flat crypt
A crowsnest.log ofc
midnight barn
yes
flat crypt
If you didn't get it, this is the moonraker.log and not a crowsnest.log
midnight barn
flat crypt
Send your /boot/config.txt
flat crypt
At /boot/config.txt with ssh
You can access it with something like WinSCP on Windows
Or wait, you can just follow that https://crowsnest.mainsail.xyz/faq/how-to-setup-a-raspicam
midnight barn
yes but no detect
flat crypt
To be more precise https://crowsnest.mainsail.xyz/faq/how-to-setup-a-raspicam#troubleshooting
midnight barn
ok ok i test it
pi@wary talonos:~ $ libcamera-hello --list-cameras
No cameras available!
flat crypt
This is expected, as written in the guide, just follow the steps after that
midnight barn
ok ty i test
[06/12/23 16:29:27] crowsnest: INFO: Detect available Devices
[06/12/23 16:29:28] crowsnest: INFO: Found 1 total available Device(s)
[06/12/23 16:29:28] crowsnest: Detected 'libcamera' device -> /base/soc/i2c0mux/i2c@1/ov5647@36
[06/12/23 16:29:28] crowsnest: Try to start configured Cams / Services...
[06/12/23 16:29:29] crowsnest: INFO: Configuration of Section [cam 1] looks good. Continue ...
[06/12/23 16:29:30] crowsnest: V4L2 Control: No parameters set for [cam 1]. Skipped.
[06/12/23 16:29:31] crowsnest: Starting ustreamer with Device /dev/video1 ...
[06/12/23 16:29:32] crowsnest: ... Done!
[06/12/23 16:29:33] crowsnest: WATCHDOG: Lost Device: '/dev/video1'
flat crypt
Now follow the top of the page
midnight barn
ty for your help today 🙂 its work
flat crypt
Then please close this post