I don't see timelapse option

[raven zodiac]

I'm trying to make timelapse but i don't see timelapse bar on left

[zenith basalt]

Have you setup: https://github.com/mainsail-crew/moonraker-timelapse

And please fix your tags #readme

[gritty oriole]

same boat, have done the setup and followed multiple videos. I can see it in the update manager, but I cannot activate the component. My printer in a FLsun v400 and arrived with klipper and moonraker installed.

[zenith basalt]

Send your printer.cfg and moonraker.conf

[zenith basalt]

Can you send the output of ls -l ~/printer_data/config/?

and of ls -l ~/klipper_config

[gritty oriole]

the passwd of the ssh login is not "flsun" as it is supposed to be on the speederPad, the default 'raspberry' doesn't work either, so unfortunately have not been able to remote in

[zenith basalt]

How did you install timelapse?

[gritty oriole]

I only updated the moonraker.conf file and restarted moonraker. It now shows up in the update manager like this, but not as a usable component on the left. I do not think it is installed correctly

[zenith basalt]

Then you didn't follow the setup.....

So you should find out your password first and then you can install it correctly

[gritty oriole]

makes sense, thank you

[zenith basalt]

@raven zodiac Can you send your moonraker.log and klippy.log, if you followed the whole installation and configuration tutorial at https://github.com/mainsail-crew/moonraker-timelapse and still can't see the timelapse bar. I think you might have just missed a step there.

[abstract smelt]

@gritty oriole be aware the V400 uses there one Klipper repo. Need to check the Speeder pad in the evening. My V400 uses a PI zero W 2 currently.

But if I remember right it did come with Timelapse pre installed.

[gritty oriole]

You are 100% right. From what I remember I needed to reflash it from the beginning in order to use ssh and have timelapse installed, however the drive sent was corrupt so I used it as-is. I reflashed tonight and nothing had to be modified after that.

[abstract smelt]

If you reflash and have ssh capability than check if

If the timelaps.py is not there than follow the steps mentioned by @zenith basalt

Also change your output path to

It might be an issue that your output folder is outside printer_data

And if all that does not help a moonraker.log would be extremely helpful

[gritty oriole]

it all works now, a reflash seemed to have solved it in one go. Both of those checkout so I'm thinking it's fine now. V sorry for jacking the post @raven zodiac ! Thanks for the help guys

[zenith basalt]

You didn't follow the tutorial according to your logs