#BED_SCREWS_ADJUST not working correctly

1 messages · Page 1 of 1 (latest)

mellow canyon
#

Hi guys - I have a question....

I'm trying to do a bed screws adjust after I've installed a Dragon Burner. I have adjusted position_max and endstop_position to 113 for stepper_x and 116 for stepper_y.

When I do the first 'adjusted' it moves from the centre middle to the rear left. Then I change the bed screw and click adjusted again - the print head doesn't move to the rear right - wtf? Why might this happen?
it also get stuck in the UI so you have to reboot the printer to do anything more...

#

I might have figured it out - turns out the bed_screws section had values greater than the max I set in stepper_x and stepper_y

valid jolt
#

Hey, as you didn't upload any config or logs, my guess would be a wrong configuration of your bed screws. I don't know why you write your endstops configuration but nothing else. Also where is rear left, rear right? It could be anywhere. There is so much information missing here hard to tell what is wrong

#

So ig I was right with the wrong config 😄

#

If your problem is solved, please close this post

mellow canyon
#

It's cool I'll close now - all sorted

mellow canyon