pallid prawn
Hey,
Setup:
Ender 3 Pro
BTT E3 RRF v1.1 with Klipper
BL Touch
Dual Z
PI 4b with Mainsail.os
I installed Klipper succesfully and tweaked in my printer config. Everythings should be working but my first layer is wayyy to high. The Z_Offset and my extruder is calibrated. If I check with Probe_Accuracy everything is perfect. I sliced with Cura and SuperSlicer both with the same problem. Also a very strange problem in SuperSlicer is this line in the Start G-Code:
-G1 Z50 F240
It literally drives my Z Axis into to the top bar so I commented it out.
Something is obviously very false and I don't know what the problem is. Maybe Something with Z config because of that strange behaviour.
Here is my printer.cfg
uncut wolf