Hello everyone! Looking for quick guidance as I have been out of printing for a while. Looked online on what to adjust but couldn’t find anything too useful. I’m doing a decent sized print that takes up almost my whole print bed. When the nozzle went to the lower right corner I got “Print out of range” still had some room for the nozzle to travel to print. Is there a formula or program I can use to enter my bed area to make sure I can utilize as much room as possible?
#Print out of range
viral flare
sick oar
you specify your bed size in the printer.cfg. Things to check:
- does max size at the stepper_x nd stepper_y is correct
- if you travel to 0:0 is that the left front corner
viral flare
you specify your bed size in the printer.cfg. Things to check:
1) does max size ...
Thank you! I believe I got it working now. Having a handful of other problems. I recently updated some of the software in mainsail and after I did that my print quality went down 😭 not sure what happened there.
rare minnow
Thank you! I believe I got it working now. Having a handful of other problems. I...
i am not aware of any update of klipper (or any other component) that could have an effect on the print quality...
viral flare
i am not aware of any update of klipper (or any other component) that could have...
I think I figured it out. For some reason there were backups of my print config. I deleted those and print quality went back to normal.
rare minnow
I think I figured it out. For some reason there were backups of my print config....
sry... but this is also not possible...
viral flare
sry... but this is also not possible...
Just saying what I saw. Multiple printer config were there and deleted them out and works great again.