trouble with my zero G xy axis layer shift

[cedar plover]

This is most likely stealthchop. to disable it, under tmc5160 section, erase the line which says stealthchop:99999

in addition, if you previously had printed parts, i would put them back.
Blurolls/Funssor are a scam. they are not approved by ZeroG and have terrible tolerances which will hurt print quality and resonances. I am so sorry you were scammed.

also, replace noctua fan. they qre risky to run as they have little airflow and can cause heatcreep

[rapid beacon]

sigh was tho great tho be tro that having them make it stronger then printed matirial

[rapid beacon]

you dont happend tho know things about tmc5160 ?

[cedar plover]

stronger is not better if its wobbly.
ABS is also lighter

[cedar plover]

i do. i run them. this is a stealthchop issue

[rapid beacon]

dose asa al so works

[cedar plover]

yes. ASA works

[rapid beacon]

have the 5160 working the scream is gone (wont mean i am save

[cedar plover]

make sure to disable stealthchop though. thats the core issue

[rapid beacon]

i did no scream and smooth so far on the motors (need tho do test print if it fails swap back tho asa towers

only sad i have no temp sensors in them for monitoring