Extends the belts 2.85mm forward, allows you to use a 5mm bolt in the back and run a M3 30 through the top into a heat insert.
#X Joint for Lightweight gantry, XOL, SB, Archetype, TAP
gritty void
serene acorn
Extends the belts 2.85mm forward, allows you to use a 5mm bolt in the back and r...
No bolt in the front for the gantry?
gritty void
No bolt in the front for the gantry?
Not enough room or thick enough. It’s actually very secure. The rear bolt holds it in place. The extra top M3 clamps down on the gantry.
shadow minnow
Are you able to tweak the design so we can install the Lightweight Gantry to hold the Rail on the front side? Looks Like is just missing a hole for that.
Unless in intended it to be held with just one M5 on each end?
gritty void
A screw would obstruct the belt path. I can send you the step files
@shadow minnow ^
shadow minnow
A screw would obstruct the belt path. I can send you the step files
Thanks
gritty void
I like the screws, I need some of those for my collection. Could have used some of those on many occasions.
shadow minnow
Yeah I discovered them with the VzToolhead
shadow minnow
Could tweak cooling but it printed nice without support
gritty void
Nice prints
turbid elm
shadow minnow
You're punishing your Hotend?
turbid elm
You're punishing your Hotend?
Ah that's where I accidentally posted these
shadow minnow
Agree wrong place. But that was a pun about he Punisher logo. 😉
turbid elm
They are in the normal server too
That's the rigs name till I change it after the first print, going back to correct server
shadow minnow
Just received my Ultra thin M5x6mm screws, I had to enlarge the Counter bore a bit. I just started reprinting them and will post the updated stl once I confirmed the fit.
the ALi specs said the Head diameter was max 8.8mm but received 9.48mm ones
shadow minnow
Took me a while to install but here's the end result
Also made a custom bumber to use the SB original endstop swich location
sonic girder
@shadow minnow What did you do to get the screw to fit? I ordered the ones from the link and they're also around 9.5mms. I'm currently turning one down in my drill with a file but its taking a long time.
sonic girder
actually never mind. Turning seems to work really well. I have a nice fit now
shadow minnow
<@209440493933821953> What did you do to get the screw to fit? I ordered the on...
I forgot to post my updated model to acomodete them.
I'll look it up later today and post them
sonic girder
its all good! The swap was fairly easy and relativly problem free. I forget how long my X rail is but it was just slightly too long for your endstop bumper. I ended up throwing in an insert into the bottom M5 bolt hole and attaching my old one. Thanks!
