KlickSwipe for Mercury One.1 | Zero G | Page 1

chrome sage Dec 30, 2023, 11:44 PM

#

I lightly modded the 1515 mount for the KlickSwipe to fit on the rear extrusion. KlickSwipe is for the V0 and developed by user So I Says on the Voron Discord so credit to him. Setup was some of the easiest I have ever done. Once everything is printed you will need to adjust your dock location for Klicky and some minor config changes, but thats it.

Here is the link to the Git for the small BOM and build instructions. Only thing to note is the macros. Go into the klicky-macros.cfg and CTL+F and search for retract. You should find to blank macros. You can copy and paste the Github items into their respective places, Save and Restart. Add the Servo to your printer.cfg and adjust the pin assignment. The rest of the instructions needed are on the Github.

I will post the longer (32mm) arms, but there are 22mm versions available on the Git. There is also a printable PTFE tubing cutter guide if you so wish.

Also, you will need to measure and drill mounting holes. I used 4 M3 screws two in the bottom and two in the back, but you can choose you're mounting hardware this way.

I included a servo cover from another model I found, have not fitted it to mine yet.

📎 a_klicky_dock_bottom_x1.stl 📎 a_klicky_dock_x1.stl 📎 a_servo_mount_top_x1.stl 📎 a_servo_mount_x1_V2.0.stl 📎 drive_arm_32mm_x1.stl 📎 free_arm_32mm_x1.stl 📎 7.STL