Z wobble?

[sharp lagoon]

What kind of filament, temperature settings and speed of your print (slow/normal/fast)?

[thin cedar]

default zerog profile, medium speed, pla print temp 200

temperature I tested and set to whatever came out best from the temp tower.

From what I can see here, my z offset is too low so the first layer is pressed. In addition, my flow rate is too low causing gaps between the infill. But I keep finding those crazy streaks in the z strange. But those stripes/ defects in the Z layers I don't know where that came from.

[sharp lagoon]

Get your flow rate right and go from there.

[thin cedar]

i will try tonight

[sturdy echo]

I have similar issue to yours, but still on merc 1.1. I pushed 300 with 10k accel and from what I can see it's lack of cooling and when I slowed down it looks similar like yours

this is when I pushed it....which I don't think it's a surprised

and this after I added layer time

it's an orbiter 2 with rapido HF combo

I've been going into different discord and forums, not sure if I'm the only one that has this cooling issue on Merc 1.1 (if it is cooling that is). and if it is cooling, then shouldn't there be others too 😅 . sorry just thinking outloud

[thin cedar]

I see some pressure advance problems with you too, Besides, the first layer is not perfect either, I would check your extruder is completely.

There is really a lot wrong with your print from what I see.

Also, have you checked if your belts are good? with something from klippain.

[sturdy echo]

thanks for the suggestions. But yes, I've done Input Shaping again last night and done another PA. First layer is fine but perhaps I'm just pushing it too fast? what would be the recommended first layer speed generally for Merc 1.1?

I will check out klippain

my latest benchy looks worse.😅

[sturdy echo]

i checked the belt resonance frequency as per build instruction

[sturdy echo]

you meant klippain shaketune instead of just klippain, yes?

[steady pumice]

Yes