What hotend do u use?
#WobbleX and Bearing Tops for E5Plus+Hydra. Version 1 installed/working.
uneven tapir
Because with my wobblex mod u can't get away without different leads crews really for top mounts. Stock sizes don't work without not touching the Z
lilac sparrow
Stock ledscrews
uneven tapir
But what hotend do u have.
uneven tapir
Stock ledscrews
Hotend length is more the issue.
Stock leadscrew don't fit really with top mounts.
lilac sparrow
Stock leadscrew don't fit really with top mounts.
Incorrect. Working here with HF (not UHF) hotend.
uneven tapir
Incorrect. Working here with HF (not UHF) hotend.
Rapido? Because like not all hotends are very long lmao
lilac sparrow
Before requiring new leadscrews I would raise the Hydra rails or bed standoffs a few mm (IF necessary, which it is not for my setup) but we're going down different paths. I don't want a redesigned motor mount, especially.
uneven tapir
Before requiring new leadscrews I would raise the Hydra rails or bed standoffs a...
I redesigned the motor mount based off mirageC opinion. Better to allow more wobble space
Standoffs were 1 the initial ideas to get away from issud
lilac sparrow
OK, good luck with your design. But it will clear the rear rail at full extension with no motor mount change.
lilac sparrow
STLs moved to this location: https://www.thingiverse.com/thing:6270544
orchid arrow
lilac sparrow
WS8 from the Mellow Store on Ali.
crystal python
@lilac sparrow still running this mod? what are the current files on your thingiverse- looks like some duplicates
lilac sparrow
<@407924515797073921> still running this mod? what are the current files on your...
Yep still using it. No problems. I'm away visiting colleges with my second kid [getting old] so can't look now but I think I'm using the older-dated Thingiverse files on the machine. The newer ones are improved but not tested. Can sort it out later in the month.
lilac sparrow
<@407924515797073921> still running this mod? what are the current files on your...
OK, It's been a while, but the Thingiverse is sorted. Simplified so there's one WobbleX carrier model, used for top and bottom on all three Hydra arms (so 6 total). Also a new slightly reinforced rear Hydra arm, just because I had a failure yesterday with my exceptionally heavy Mic6 bed. So the parts are current now.
crystal python
OK, It's been a while, but the Thingiverse is sorted. Simplified so there's one...
do you have pics?