Extrusion problem on layer change and mirroring | Zero G | Page 1

tribal harbor Jun 7, 2023, 11:10 AM

#

What are these lines from and why are my print mirrored?
I only get those lines on the back of my cube where the layer change…?

next bramble Jun 7, 2023, 11:42 AM

#

If your print is mirroed you might have a wrong klipper config or slicer setup.
Check if the motors are working in the right direction and if position 0.0 (x0 y0) is in the front left corner. (See picture)
And in the slicer check you build plate settings if position 0.0 is in the front left as well.

tribal harbor Jun 7, 2023, 11:50 AM

#

tribal harbor Jun 7, 2023, 2:55 PM

#

Thanks, i will check on it after work!

#

I used ratos for my klipper config

tribal harbor Jun 10, 2023, 1:24 PM

#

So after multiple test, G1 y0 goes to front. G1 x0 goes to right….

next bramble Jun 10, 2023, 1:38 PM

#

tribal harbor So after multiple test, G1 y0 goes to front. G1 x0 goes to right….

G1 X0 should be front left
You mixed something up in the klipper config and the motors are swapped 🙈

Endstop position on y-axis is 235 or more
And endstop x-axis should be 235 or more

tribal harbor Jun 10, 2023, 2:44 PM

#

I should probably not use ratos to configure my printer. I’ll start from scratch. Ratos is kind of complicated to modify. Thanks for the help Banana3D_Printing(Marco)#1803

#Extrusion problem on layer change and mirroring