#what should the z-tilt tolerance be?

27 messages · Page 1 of 1 (latest)

grand fjord
#

i had the stock e5+ z-tilt tolerance set to 0.0025. the hydra says samples exceed tolerance. should this setting be changed? Thanks

spiral forum
#

are you using 3 points or 4 points in setting the tilt

grand fjord
#

3 points. it finishes the routine. but takes alot more tries than it did originally with stock 2 point. On a weird maybe related point. now when I try to run a bed mesh calibration it picks up the klicky and then throws this error : Move out of range: 11.500 -9.750 10.000 [0.000]. not sure what it means.

spiral forum
#

post your config

grand fjord
#

also changed to tolerance to 0.01 which seemed excessive

#

but i'm most likely incorrect

spiral forum
# 
# Driver2
[stepper_z]
step_pin: PF11
dir_pin: !PG3
enable_pin: !PG5
microsteps: 16
rotation_distance: 2
endstop_pin: probe:z_virtual_endstop 
#position_endstop: 0.5
position_min: -15
position_max: 400

Z min is not low enough

#

I tend to use -15 to prevent errors

#

you can go even more if needed

grand fjord
#

groovy done

#

thanks

lyric ravine
#

.05 on my pro for 3 point

grand fjord
#

am i correct in thinking the probe points should be where the bed attaches to the tanks?

spiral forum
#

they do not need to be

#

but you also need to account for probe offset

#

I always mix up the math on how to shift the values

#

so the values shouldn't be the same.

grand fjord
#

i tried to get the probe directly over the bolt locations but the front just doesnt reach

#

gets close tho

spiral forum
#

I try to probe a bit off the mini tanks, since there can be a slight divot over the holes.

lyric ravine
#

i probe over(in line with) the arm as close to the tank as possible without being directly over the screw,

grand fjord
grand fjord
lyric ravine
#

change position min on y

grand fjord
#

actually think i might have figured it out. i realize i didn't change the bed size in klicky varibles. unfortunately my ebb36 just stopped working again so ill have to text it out later

grand fjord
#

nope that wasn't it