indigo steepleBOT
sharp flame
For the AP, as you can see on your PFD, you're overspeeding, which disconnects AP
This is because your throttle isn't in the CLB detent, which is where your plane is asking you to put it (see LVR CLB)
Because of this, autothrottle isn't gonna do anything
steady merlin
This is because your throttle isn't in the CLB detent, which is where your plane...
I am sure, that after departure and after checking with checklist. There 100% was Climb.
sharp flame
Regarding the flight plan, your screenshot is a bit poor since your ND is at enroute range setting meaning approach/arrival waypoints aren't displayed. I do see however that the first leg before the destination runway is an arrival leg, which is wrong.
sharp flame
I am sure, that after departure and after checking with checklist. There 100% wa...
If it flashes LVR CLB, it isn't in CLB
You may have knocked it by accident
sharp flame
What approach did you load? Did you verify it was correctly loaded, and did you delete any parts of it (including discontinuities)?
steady merlin
There were no discontinuities.
And before departure, i was checking the route, and everything was as it should.
sharp flame
Usually you have an approach loaded.
Doesn't seem like there's any in your screenshot
steady merlin
That is the problem.
sharp flame
Yeah but then I need more info
What did you select? What was actually there? And I can't see what's there because the screenshot shows the ND at 160NM
steady merlin
I don’t know more. I just programmed my arrival in the f-plan. And then I departed with clear view on the flight route. Then, as I said went afk for like 3 mins, the incident with the Ap happened and i saw the arrival like this. (Not the fist time this happened to me, and as I saw it happened to others too)
This is everything that happened
steady merlin
What did you select? What was actually there? And I can't see what's there becau...
And also I wanted to ask, what to do if I get some f-pln discontinuity between waypoints? Should I just clear them? Because I did not uderstand the tutorial in th MCDU programming section.
elfin fern
It's not straightforward, sometimes it's appropriate to delete them and others not (i.e. if it would cause a course reversal without a course reversal leg)
And sometimes their existence indicates you have selected incompatible combinations of procedures/transitions
steady merlin
And sometimes their existence indicates you have selected incompatible combinati...
Very complicated
steady merlin
And sometimes their existence indicates you have selected incompatible combinati...
But do you know what could cause the problem above?
elfin fern
groundspeed of 575 knots => the turn overshoots
steady merlin
So it happened because of the ap failiure?
elfin fern
elfin fern
So it happened because of the ap failiure?
It's working as intended. No failure
elfin fern
The AP disconnects when high speed protection activates, that is intended
High speed protection was caused by manual thrust setting
Perhaps you might want larger deadbands for your throttle calibration if you're having difficulty with the detent sensitivity https://docs.flybywiresim.com/fbw-a32nx/feature-guides/flypados3/throttle-calibration/
steady merlin
Ok