#Phottix Mitros+

19 messages · Page 1 of 1 (latest)

odd novaBOT
#

Congratulations @somber tundra! You have earned the Freshman (25+) role!

regal stirrup
#

can you change the fresnel zoom when the flash isnt mounted to the camera?

somber tundra
#

Nope. No matter the config it's locked to Mzoom 14mm

regal stirrup
#

are you in full manual flash mode?

somber tundra
#

The problem is there in both manual and ETTL

regal stirrup
#

even with the flash detatched?

somber tundra
#

Aye

#

It cycles when I start it btw. So the mechanism isnt broken

regal stirrup
#

im ngl itll be hard to diagnose further for non standard flashes since phottix is some unknown rebrander

#

can only recommend reflashing firmware if thats even possible on your flash

somber tundra
#

It is, and I did, with the latest update. Still the same, but when I booted it up, it was set at 105mm untill it cycled the zoom and locked in at 24mm again

#

Should I open it up and see if the diffuser retraction mechanism isnt doing what it's supposed to?

Some sources say never open a flash, but others say to just disconnect and wait until it discharges

regal stirrup
#

esp if you dont know the internals or how the flash is built

#

esp the fresnel head, most cheaper flashes are never built with repair in mind

somber tundra
#

Allright.

So, I got the mitros and an odin transmitter for about 30 dollars, so it's not a big loss.

My intent was to use it for fill outside on bright days. Will it still work for that even if the fresnel head is locked to 24mm or should I just scrap it?

regal stirrup
#

it wont concentrate power to account for a narrower fov

#

for fill flash i doubt it will have any effect since you'd be using modifiers on your flash if you didnt want spill