Display not showing on nice!nano v2

[covert pendant]

(sorry if this gets asked a million times)

I now found the reset on zmkfirmare github, going to try reset the board with that

[lapis hearth]

• remove nice_view_adapter and nice_view from your build.yaml (the nice!view is designed to replace an OLED; it is not itself an OLED)
• you will need CONFIG_ZMK_DISPLAY=y in your config/*.conf file
• you will need to make sure the OLED has consistent power when the keyboard starts up
  • measure the VCC pin on the OLED with a multimeter; should be 3.3V
  • no multimeter? can't verify the results then, but assign &ext_power EP_ON in your keymap, press that key once, and wait at least 60 seconds for the "external power is on" setting to be saved to memory before using the physical reset button on the keyboard or pressing &reset

[covert pendant]

Thanks a lot for the response! Do you think reseting the board with the zmk settings reset flash will help at all? or do you just suspect that I did the settings wrong maybe

I'll try the settings you said first, thanks again

[covert pendant]

This was the solution, another case of "dummy user error" thank you for your patience with people like me haha

tried deleting post hmm

[lapis hearth]

You're not dumb for not knowing how all this stuff works. ❤️