Hello! I’m trying to upload a code onto crashworks 3D Alisha board (i just adjusted the 160 degree to 180 since i have a little bigger mask) but it doesn’t give any errors it is just stuck saying uploading.
#Alisha board not uploading
peak aurora
trail garnetBOT
Hey @peak aurora, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
dim willow
Which board are you using? Esp32 based board (MKE) or the Arduino nano based board (MK-X ) ?
peak aurora
Which board are you using? Esp32 based board (MKE) or the Arduino nano based boa...
Esp32
peak aurora
Which board are you using? Esp32 based board (MKE) or the Arduino nano based boa...
Crashworks say to put the board as the arduino nano not the Esp32
peak aurora
Which board are you using? Esp32 based board (MKE) or the Arduino nano based boa...
This is all it’s stuck saying
trim tapir
Are you using the code from our public repository or private repository exclusive to people who have purchased one of our MKE series boards?