✅ - I'm not sure what this type of failure is called but how do I fix it

[weak oak]

I just got this used Halot R6, any ideas why this is happening and how I can fix it?

[severe phoenix]

Hey @weak oak, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[weak oak]

These are my settings and It succesfully printed a different mirrored version of this one no problem on the same print

So im thinking its an issue with just the plastic trough but im not sure

[gray vapor]

Could be a lot of things. Have you calibrated your exposure times with something like the cones of calibration or similar?

How did you orient it?

What kind of supports did you use?

If you had a failed print prior to this (even just a single suppport failing) and didn't do a tank cleaning exposure, that can cause stuff like this too.

[weak oak]

This is how I oriented it I used the normal tree supports medium 5mm off the plate, I have not used the cones but this was my first use on it I full deepcleaned the printer when I got it(Since it was used) and used the lcd burn thingy to pull of a layer and that came off fine

Figured it out theres a hole in my plastic sheet

New question

Any way to fix that or do I just have to buy a new one

[severe phoenix]

This thread is closed now :white_check_mark: