My shield prints all had a fail at the exact same spot where it’s like the layers didn’t stick.
(All 3 were on the plate together and oriented the same way)
Anyone know what caused that /how to prevent it from happening again?
#Anyone know what caused this layer fail?
astral moon
stark waveBOT
Hey @astral moon, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
ivory bear
Did you check the gcode preview?
astral moon
Did you check the gcode preview?
Yea everything looked normal like every other print Ive done
ivory bear
Hmmm you could reformat the sdcard and see if its working again.
chrome tartan
Is it exactly the same spot down to the mm or is it just a very similar spot?
Were they printed together on the same print or were they seperate prints?
If its exact and printed separately then there is something up with either your sliced model or your SD card or something is jammed in your lead screws.
If not exact or they were printed together it could be a nozzle clog, you could have poor layer adhesion and it just delaminated and warped there. (print hotter and/or slower and/less cooling)
Also you need an actual brim for something that large and long. Mouse ears will not cut it.