maiden kelp
Doing a flow calibration test on the Ender 3 Pro using orca Slicer. I already Calibrated the E steps and Z offset for the printer. A few minutes uses ago I started the calibration test for Flow. Starred seeing parts of the test print look correct but the sides of them look to have some sort of fades? Not sure if I need to level the bed again or what the issue is.
river chasmBOT
Hey @maiden kelp, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
maiden kelp
I also already tested for under extrusion and over extrusion
maiden kelp
The bowdentube is secure on both pushfits with a clip?
Sorry for the late response yes it is. 😅
proper narwhal
Okay do you use a capricorn tube?
maiden kelp
Yes
proper narwhal
I would suggest you replace it with a normal one. It requires such a tight filamentpath that without one time bends can case permanent choke points or if it bends too strong it clamps down on the filament.
Also since its smaller then the diamenter of the hole of the nozzles side you feed in you can get clogs :/
Oh a bit to tight zipties can also cause it clamp down on filament