✅ - Tree support under extrusion

[wide wagon]

I've just gotten my Ender 5 Plus set back up after not using it for a few months, and everything seems to be printing just fine except for the tree supports on my piece. They're the only thing that's under extruding. Any explanation for this?? The print is solid and extruding fine on the main piece. I'm confused.

[junior gyro]

Hey @wide wagon, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[swift scroll]

did you dry the filament?

[shut lynx]

different retraction values for tree support maybe

[wide wagon]

A fresh roll, just unwrapped. I stopped the print and pulled the main piece off and it didn't have a single flaw. I'll need to go check my Cura settings, but I haven't touched a thing and this is my first run in with this

[shut lynx]

Filament gets water temperd due production. Its always wet even fresh out of the box

[junior gyro]

This thread is closed now :white_check_mark: