✅ - under extrusion | Frankly Built's 3D Printing & Cosplay Community | Page 1

quartz whale Sep 1, 2024, 11:24 PM

#

Printers: elegoo Neptune 3 plus and MAX
Filament: zyltech
Temps: 210(nozzle) 60(bed)
Speed: 60mm
Slicer: cura 5.1.1

Iv been printing for a while now and mostly get good prints. Lately on all three of my printers (2 EN3p and 1 EN3M) Iv been getting points of under extrusion.

Usually this happens in the same locations with the same models no matter which printer I’m using so I’m thinking it’s slicer related? Iv used cura since I started but am not sure what the issue is here.

Any help is MUCH appreciated thank you!

cosmic marlinBOT Sep 1, 2024, 11:24 PM

#

Hey @quartz whale, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

quartz whale Sep 2, 2024, 2:21 PM

#

under extrusion

cosmic marlinBOT Sep 2, 2024, 5:06 PM

#

cosmic marlin > Hey <@644182568408842241>, thank you for contributing to this forum. > Please...

This thread is closed now :white_check_mark:

#✅ - under extrusion