chilly flint
Hello,
I’m using Cura and manually swapping filament for Hueforge designs until I can afford a bambu. This current one I’m doing was paused waiting for me to put the last color in (white). While at work the power went out.
Is it possible to leave the print on the bed. Re slice the model with just the white layers and print? Or will it try and print the white directly on the bed. Also when doing its 25 point level check it will hit the print with the probe
sharp basinBOT
Hey @chilly flint, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
tepid spoke
You should be able to modify the gcode to make it start from that specific layer, tho im not able to do it
@rigid grail should know smth about it
rigid grail
hi
chilly flint
Hi
This print was looking awesome. With a bunch of manual filament swaps. Sucks to loose it.
rigid grail
im pretty sure you could
chilly flint
Just need it to continue on the final white layers
tepid spoke
Doesnt the print have a resume function?
chilly flint
I turned power loss off because it was causing zits and blobs on my print 😢
tepid spoke
Ohh yeah makes sense
chilly flint
When writing to the SD card it would blob a little
chilly flint
im pretty sure you could
Tell me you know the secret 🙏
chilly flint
I have the gcode. Pretty sure I just need the bed & nozzle to heat up and move to the proper layer start position.
No bed home/bed levelling sequence or prime line. But that’s way beyond me
chilly flint
so i found the layer it did the filament change at and deleted every layer before that. then i deleted the gcode for startup sequence; home, 25 point bed levelling, purge lines. so if i understand this right it will run this code and set all my values. start the filament change command which will allow me to load the white, it will then purge and move into position?
rigid grail
Should do
Aslong as you haven’t restarted the printer
Because it’d been zeroed from where it started rather then using any offsets it had
rigid grail
Hello,
I’m using Cura and manually swapping filament for Hueforge designs until...
Hang on wait the CR10s pro v2 has power outage protection
chilly flint
i turned it off because it was causing zits/blobs on my prints
i will try it again for hueforges and see how it looks
chilly flint
Aslong as you haven’t restarted the printer
what are your thoughts for leaving the M600 filament change command in there>
chilly flint
Because it’d been zeroed from where it started rather then using any offsets it ...
the printer entered the filament change sequence and moved the head to the front left corner. the power went out then came back on. now the screen is on the main screen display. so i would manually set the nozzle and bed temp. load the white filament then hit print.
