Hey I’m having problems with my filament getting jammed up. I took apart my hotels cleaned it and re assembled it kept it looser and put the Bowden tube in then tightened it to smoosh the tube and keep it from moving too much(I have one of the blue tubes not sure if it’s actually a Capricorn tube or a knock off) I’ve tried changing my filament out for a different type also and same issue. I’ve also tried re-leveling it and trying different prints to see if it’s just a print issue but same issue with clogging and clicking I get around one layer maybe two if I’m lucky which makes me think heat creep but I preheated it let it sit for a while then extruded it and didn’t have an issue until I started printing. I’ve tried multiple cold pull but with pla not nylon and it looks like the melted clog is long and wider than the rest of the filament which isnt making sense to me. Please help just want to finish my full mando cosplay!!!
#✅ - constant clogging
gilded thorn
hollow orioleBOT
Hey @gilded thorn, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
gilded thorn
My printer is an ended 3 V2 neo also
hollow orioleBOT
> Hey <@759588745245884468>, thank you for contributing to this forum.
> Please...
This thread is closed now :white_check_mark: