iron man helmet printing | Frankly Built's 3D Printing & Cosplay Community | Page 1

south reef Mar 12, 2024, 8:51 PM

#

I am making a Mark 3 helmet and I am having trouble with the actual helm I have tried 3 prints and keep getting stringing and weak prints I am wondering what I can do

crisp mulchBOT Mar 12, 2024, 8:51 PM

#

Hey @south reef, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

south reef Mar 13, 2024, 3:03 AM

#

low dome Mar 13, 2024, 3:34 PM

#

What’s your infill? It looks like 0%

south reef Mar 13, 2024, 7:13 PM

#

low dome What’s your infill? It looks like 0%

15

low dome Mar 13, 2024, 7:58 PM

#

south reef 15

Have you dried your filament?

south reef Mar 13, 2024, 7:58 PM

#

No

low dome Mar 13, 2024, 7:59 PM

#

Try drying it. That should reduce stringing and increase layer adhesion

south reef Mar 14, 2024, 7:18 AM

#

Ok what do you recommend for drying

low dome Mar 14, 2024, 1:02 PM

#

Ask in #chat-printing. I have a filament dryer, but there are more methods that I can’t explain well

marble monolith Mar 15, 2024, 11:10 PM

#

Try printing it right side up, use snug support around the bottom and a small spot in the center of the dome. That was the only way I had success. I tried printing it upside down a few times and couldn’t get it to work. Also as others said, dry the filament if possible.

#iron man helmet printing