✅ - Maybe Clog?

[short storm]

i use a needle to clean the clog i had with the black piece, i was printing some webshoothers (blue piece), it is not as bad like the black piece but theres still trace of the problem, should i clean again? i normally do cold pulls to take any possible clog or when i change colors, i only have print pla

[earnest spear]

Hey @short storm, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[short storm]

another piece, i hope it is able to see

[dim panther]

hard to say since some areas are fine above the problem layers. Does your filament allow for a higher temperature? Maybe the nozzle is not high enough?

[short storm]

i know right, the print turn out fine, but that little detail, i can, i print at 210, oh its pla+ forgot that detail

[dim panther]

Elegoo pla+ is what I use and I have my nozzle temp at 215 and bed at 60. What printer do you have?

[short storm]

ender 3 max neo

[earnest spear]

This thread is closed now :white_check_mark: