I looked at the nozzle and I have filament I don't know what the problem is
#Won't print I have no idea why
hollow yew
charred perchBOT
Hey @hollow yew, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
urban delta
Send some photos/videos and I might be able to help you out more!
hollow yew
Ok
hollow yew
Send some photos/videos and I might be able to help you out more!
The model is a Neptune 3 plus
urban delta
Do you have a file loaded into it?
Is it sliced to the correct printer?
Do you have the filament loaded correctly? Is it extruding?
hollow yew
Do you have the filament loaded correctly? Is it extruding?
Yes Yes Yes and No
urban delta
So the filament isn’t extruding?
hollow yew
Yea
urban delta
Heat up the nozzle to 220
Then push the little lever and feed the filament through until it goes through.
It may take a couple tries but it should work
hollow yew
It may take a couple tries but it should work
It started
fickle warren
You didn't push it far enough at first. Looks clean now.
fickle warren
New printer? Check wires? Has it printed before?
hollow yew
It is a new printer and it hasn't printed yet
fickle warren
ya I would check the cables and the stepper. tell the pritner to extrude x amount and see what it does.
then if ecerything checks, tell it to print from the test models the SD came with.
urban delta
Like he said check your wires. You might not have plugged everything in securely yet.