✅ - My prints are not sticking to the bed | Frankly Built's 3D Printing & Cosplay Community | Page 1

last mortar Jan 6, 2024, 5:24 PM

#

Whenever I print something on my ender 3 v3 se, it gets unstuck half way through the print and slides around on the bed. I auto leveled it twice, and tried increasing heat of the bed, but the issue was not solved. Anyone know a solution to this?

gray eagleBOT Jan 6, 2024, 5:24 PM

#

Hey @last mortar, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

dawn olive Jan 6, 2024, 5:47 PM

#

I have an ender 3 v3, what slicer are you using?

#

And if you could send a video of your issue it would be better

last mortar Jan 6, 2024, 6:24 PM

#

Im using the Creality Print slicer

gray eagleBOT Jan 6, 2024, 6:34 PM

#

gray eagle > Hey <@795692287547932724>, thank you for contributing to this forum. > Please...

This thread is closed now :white_check_mark:

#✅ - My prints are not sticking to the bed