I’m not too messed up about them I’m just gonna finish it before hand and prime it, it’s a present for my sister
#any tips on to prevent these lines from happening?
neat flume
modern citrusBOT
Hey @neat flume, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
signal pawn
The light angle is terrible, makes every layer line visible, anyways on your slicer swith the wall ordering to "outside to inside"
In cura it's "wall ordering"
In prusa it's somethin like "outer perimetres first"
white moon
I’m not too messed up about them I’m just gonna finish it before hand and prime ...
i know my fix is a lot of work but what i did on my ender was
take most of the thing apart and put it back to gether as securly and tight as i could
i would only recomend this if your ecperianced tho
you could just tighten up every nut and bolt you can see then make sure the belts are good and tight but not too tight
that helped me
signal pawn
Yeah thats another thing
It's enough to see if the gentry is loose or the bed is leveled
neat flume
Alright, yea I’ve been troubleshooting all week to print this thing I got a special blue gradient PLA and my extruder gear was grinding it up
and I didn’t know what the problem was cuz I thought it was something else so I tried my basic white and it worked fine
But maybe I’ll give what y’all said a shot
signal pawn
Maybe it could be some moisture in the filament
white moon
Alright, yea I’ve been troubleshooting all week to print this thing I got a spec...
was it at the right temp?
neat flume
Maybe it could be some moisture in the filament
It was brand new
I could try dehydrating it tho
white moon
I could try dehydrating it tho
if its pla it doesnt matter
neat flume
yeah it is
signal pawn
Then its not it
I mean it's not moisture
Although i actually did find some differences
I use pla+ and the moisture matters
Sunlu's one
So it depends on the pla you're using
white moon
I use pla+ and the moisture matters
hmm interesting
i only use elegoo pla and plus really but its fine for me