✅ - Weird lines on my prints… along with stuck together parts

[polar salmon]

So I was printing swords/lightsaber tests and I have no clue what could cause these lines, any wisdom?

[native mirage]

Hey @polar salmon, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[polar salmon]

sorry for the bright pictures not much I could do about it ;-;

but essentally where the layers end theres a line, and even with random seperation it doesnt seem to stop

[iron wren]

That's your z seam. Some ways to make it a little less noticeable is make sure your retraction is calibrated and have nozzle wipe set can help too

[polar salmon]

ah ok

so some stuff to enable would probably be "retract at layer change", I guess that already would change a lot :P

alr cool Ill f around with it until I get something good, I appreciate the help

Im still getting used to cura so its hard to find all these lil settings.

[polar salmon]

thx :D

[native mirage]

This thread is closed now :white_check_mark: