✅ - filament caked to print bed. how do I clean it | Frankly Built's 3D Printing & Cosplay Community | Page 1

meager walrus Oct 19, 2023, 1:51 AM

#

So I noticed way too late that my nozzle was too close to my bed. It caused a clog mid print and stopped printing. Since I didn't have any cleaner at the time it had to wait about a week until I had time to go to the store. So I unclogged the machine fine but now the filament is stuck to the bed. I tried using 90% isopropyl on a microfiber cloth but it's not going anywhere. Is this something that needs a deeper clean so that I can have good adhesion or would glue stick work fine on top?

paper marshBOT Oct 19, 2023, 1:51 AM

#

Hey @meager walrus, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

desert pebble Oct 19, 2023, 10:10 AM

#

Isopropyl Alcohol 99%

#

With a microfiber cloth

paper marshBOT Oct 20, 2023, 12:26 AM

#

paper marsh > Hey <@622964559438807051>, thank you for contributing to this forum. > Please...

This thread is closed now :white_check_mark:

#✅ - filament caked to print bed. how do I clean it