narrow pagoda
Hey my last couple prints have had this issue. You can see the supports embossed on the outside of the print . My wall count is at 3 . I'm using .02 layer height . It happens no matter what infill type .
Elegoo Neptune 3 plus
Sunlu PLA plus
Print speed 60
220 heat
60 heat bed
Z seams - smart hiding
Infill overlap .02
fluid cobaltBOT
Hey @narrow pagoda, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
swift kite
Change your wall layer count to 5 or 6
I had the same problem also. Your wall count is too thin.
hearty cloud
Whats your nozzle size/ wall thickness?
For 0.4mm nozzle 3 layers thick enough.
If so you should decrease the infill wall overlap settings
Also check if you have infill printed first or the wall first.
If the infill is printed first, the print will be stronger but the infill will be more visible through the wall
narrow pagoda
Whats your nozzle size/ wall thickness?
For 0.4mm nozzle 3 layers thick enough.
...
What setting do I go to , to see which is printing first ?
hearty cloud
In Cura,
Infill
Infill before walls (uncheck it)
forest crow
are you by chance printing infill before walls? typically I see that when that's the case. When the infill prints first the walls get pushed to shape around the infill resulting in what you're seeing there. if the walls are extruded first you should have much less visibility on what's inside
hearty cloud
are you by chance printing infill before walls? typically I see that when that's...
Read the previous messages